![]() ![]() Having the right size and the right type of bit is key in ensuring the highest standard of work and ensuring that you can drill with confidence and accuracy. This drill-and-tap technique can also be used to make a square or rectangular cutouts in tile.Drill bits are cutting tools that are used to remove material in a piece to create a circular hole. The hole edge will be rough, but you can hide it with a decorative escutcheon plate. Tap inside the outline and be patient, as it could take a couple of minutes before the center of the hole breaks free.Then take a hammer and very lightly tap the tile along the ring of holes. Use a ¼-inch masonry bit to drill a series of closely-spaced holes around the circle.Draw the hole outline on the tile with a felt-tip pen or grease pencil.How to Drill a Large Hole in Tile Without a Hole Sawīut what if you need to bore a 2-inch hole for a plumbing stubout? Contractors typically use expensive hole saws with carbide-grit cutting edges, but there is another way. Regular twist-drill bits can’t cut through the fire-hardened glaze. Once you’re done drilling, push the anchors in place, screw the hardware home, and vacuum up the small amount of dust.Ī carbide-tipped masonry bit is the best drill bit to use for bathroom ceramic tile.This will extend the hole into the drywall or backer board with minimal damage. Now you can speed the drill up while backing off the pressure. You’ll feel a change in resistance when the bit gets through the tile.Steady pressure and a medium speed will drill the hole without overheating and damaging the drill bit.Once the hole is started, you can increase the drill speed, but don’t run it at full speed.Go slowly, particularly at first, to make sure the hole ends up where you want it.The tape not only makes it easier to mark the wall but also helps to keep the drill bit from skidding when starting the hole.Try to locate the hardware close to the center of the tile – the edges crack more easily. ![]() ![]()
0 Comments
Leave a Reply. |